Hello,
One of the 3D sticky of my new Hs12 has a problem returning to the mddele (central point). Fiscally looks in de middle, but the diggingarm of my escavator keeps going after I loos the joystick. If i help it to get at the cenfral point it will stop, but after a new movment, same story again. Trimming or adjusting the servo travel wont help!
It also feels like on the one side need more movement than the other to start working.
It feels as the tension of the returnig spring of the joystick is not the same on both side of the travel from the middle point to up or down. Sinds is a 3D stick, I cant adjust the spring tension like you usuly can on a standard joystick.
Can any one tell my what to do to allve this problem?
Thank you!
