Beiträge von itpaco

  • Problem with Light Brake on Trailer

    Hi,


    i've checked the connections.


    At the moment i 've the following situation:


    1) light off on track and semitrail. When i brake the light brake on track and semitrail switch on.


    2) light on track and semitrail. When i brake i don't have the two levels of light and i don't see an increase in the light.




    On Airu the connections are: from J19 to Tamiya and stand/side ports(bypass between Tamiya and stand/side ports). Jumper on the left position


    On AMO i've connected (i've a series from two red led and series with a resistance 390 Ohm alimentation 7,2V)from + and standl/rear.


    The information about two differente levels of light on AMO are detected only from negative pin of j19? on AIRU i've two different levels of tension from MCF1 (3.7V and 4,2V). The exit level tension on AMO (between + and stand/side) it's only one (6.9V).
    It's necessary a particulare configuration of AIRU and AMO.


    Thank's

  • Problem with Light Brake on Trailer

    Hello,
    I need yours support for correct functionally.


    I purchased AIR-U and AMO to use them with MFC01.


    My problem is with the brake light on the trailer. I've connect the J19 (MFC) with pin "Brake" on AIRU and i've only position light on trailer. On MFC the position/brake light it's on only one led with two levels of light. On AIRU/AMO is it possible these two levels of lights? What'is the scheme for connections with MFC01, on AIRU and on AMO?


    On AMO is it possible to use the switch for legs with other Speed Controller or only with your? if it's possible with any Speed Controller, what is the scheme connetcion?


    Thank's
    Paolo